TOSHIBA Toshiba TLP-B2 free download

File name Toshiba TLP-B2.rar

FILE NO. 333-200002 SERVICE MANUAL 3LCD DATA PROJECTOR TLP-B2 DRAFT SAFETY PRECAUTION WARNING: Service should not be attempted by anyone unfamiliar with the necessary precautions on this projector. The following are the necessary precautions to be pbserved before servicing this chassis. 1 . An isolation Transformer should be connected in the power line between the projector and the AC Iine before any service is performed on the projector. 2. When replacing a chassis in the cabinet, always be certain that all the protective devices are put back in place, such as; non-metallic control knobs, insulating covers, shields, isolation resistor-capacitor network etc . 3. Before returning the set to the customer, always perform an AC Ieakage current check on the exposed metallic parts of the cabinet, such as terminals, screwheads, metal overlays, control shafts etc. to be sure the set is safe to operate without danger of electrical shock. Plug the AC Iine cord directiy into a AC outlet (do not use a line isolation transformer during this check). Use an AC voltmeter having 5000ohm per volt or more sensitivity in the following manner: Oonnect a1500ohm 10W resistor, paralleled by a 0.15 uF, AC type capacitor, between a known good earth ground (water pipe, conduit, etc.) and the exposed metallic parts, one at a time. Measure the AC voltage across the combina- tion of 1500ohm resistor and 0.15 uF capacitor. Reverse the AC plug at the AC outlet and re peat AC voltage mea- surements for each exposed metallic part. Voltage mea- sured must not exceed 5.25V(rms). This corresponds to 3.5 mA(AC). Any value exceeding this limit consti- tutes a potential shock hazard and must be corrected immediately. PRODUCT SAFETY NOTICE Many electrical and mechanical parts in this chassis have special safety-related characteristics. These charac- teristics are often passed unnoticed by a visual inspection and the protection afforded by them cannot neces- sarily be obtained by using replacement components rated for higher voltage, wattage, etc. Replacement parts which have these special safety characteristics are identified in this manual and its supplements; electrical components having such features are identified by the international hazard symbols on the schematic diagram and the parts list. Before replacing any of these components, read the parts list in this manual carefully. The use of substitute replacement parts which do not have the same safety characteristics as specified in the parts list may create shock, fire or other hazards. ULTRAVIOLET DANGER IN SERVICE MODE Eye damage may result from directly viewing the light produced by the lamp used in this product. Always turn oft lamp before opening this cover. Ultraviolet radiation eye protection required during servicing. CONTENTS SAFETY PRECAUTIONS...